Alternate the holes on each side of center
Finally secure the lower step midway up the leg using screws & adhesive.Position the 3/8" plywood braces on the outside face of the legs butting into the the bottom face of the main stretcher.html. These saw horses will easily take the load of a lift of plywood or studs. On the main stretcher mark a line 1-1/2" from each end.Get more information including material and tool list and photos of these saw horses at heavy-duty-saw-horse. Repeat for all the legs.
Start out by measuring and cutting all your stock according to the cutting list and set it China Screw And Barrel For Rubber Machine Company aside. The leg tapers to 3-1/2" at the bottom. Mark your lines, clamp the stock on edge and cut. Secure with screws only. This cut is best made with a circular saw.Now draw 2 lines down the length of each top step, offset 3/4" from center. This is the top of the leg.That's all there is to it. Countersink 5 holes, 3/4" deep in each step. Space about 8' apart and secure a 2 x 10 between them. Take the legs and mark out the tapers.
Alternate the holes on each side of center.Apply some glue to the angled side of the leg and position on the marks you just made on the stretcher.Time for some assembly. Position the top onto the stretcher flush with the ends. Flip the stock over to the other edge and make the through cut. Scribe the angle onto the braces with your pencil and cut. This is the outer face of the leg. Plus the make a great scaffold. Secure with 4 - 2" screws. Repeat for all the legs and cut out.
The taper starts 20" up from the bottom. Apply some glue to the outside of the legs and secure the braces with 6 screws, three into each leg.html.The legs join the main stretchers at 75?. Now make a second mark in from one edge 1". Read more articles at wood-working-articles. Do this for each leg on both stretchers.
